Manx Club

I recently got a fuel injected super running. I hope to never see another fuel injected motor. The fuel pump is high pressure, and expensive. There are a lot of pieces of fuel lines with lots of connections to possible leak. Plenty of sensors and I’m sure the ecu is getting harder to get. There is a...

I’ve got friends who have been using them for years with no problems. You might consider a torsion adjuster also if you’re at that point in a build. I went to 3x3 arms and torsion adjuster. Setting the droop was real nice.

Rob and Dave’s lists the torque at 165 ft/lbs. I haven’t used a torque wrench but I crank them tight as hell.

It’s close to a Manx but not quite. No bump on the front of hood for Manx badge, dash is wrong, cutout around engine is bigger than a Manx. Engine looks more like a Volkswagen more than a Porsche. Many people use the name Manx as a general term for a fiberglass buggy, like Kleenex or Qtips. It’s see...

Very nice project and pictures of the process.

It could be the shifter adjustment or the plastic bushing in the tunnel under the shifter. Check the joint at the trans also. After that it might be a broken nose cone on the trans or as stated something inside the trans.

I don’t think anything original would fit your application. You’ll probably have to make your own top.

I think they can be replaced without pulling the engine. Take the intake end castings off, remove the two screws and they should lift off. I don’t know if there are any thicker ones though.

Nicely done and sounds good.

Seems like photobucket has blocked a lot of my pictures from this site. What I read is that they want $400 a year to allow me to show them here. Anyone else having problems?

When do the calendars go out or did they and I screwed up on my order?

Maybe never mind. I just saw a couple of Facebook posts of people getting the calendars.

Punch it next time.

You're doing an outstanding job. Keep up the good work and the pictures coming

Mine is the 2' the manxter looks like 3'. I drilled a hole in the top bars but there is a stainless bracket which comes with the latch

Nice looking buggy. It looks like a Corsair body similar to mine.