Page 1 of 1
E-brake cable sleeve to drum?
Posted: Fri Dec 23, 2005 11:54 pm
by Gene-C
I have bought the replacement E brake cables and they came with the cables and the sleeve that goes from the chassis to the drum.... Now where do I find the little piece of tubing that connects the sleeve with the chassis tube? Its like a two inch section of tube that links/goes between the chassis exit tube and the sleeve to the drum, thanks!
Posted: Sat Dec 24, 2005 12:08 am
by newmanx59
The outer cable casing should fit over the tube that sticks out the back of the tunnel and the other end of the outer casing mounts to the brake backing plate. I know of no other pieces. The cable/casing should all come as one unit.
Posted: Sat Dec 24, 2005 12:17 am
by Gene-C
So there is no tiny section of tube between the casing/sleeve and the chassis exit tube (the one that sticks out the back of the chassis/frame horns)? Just the casing/sleeve straight into the chassis exit tube?
Posted: Sat Dec 24, 2005 12:21 am
by Gene-C
hope this helps MURZ
Posted: Sat Dec 24, 2005 12:31 am
by Gene-C
Thats it! so the rubber/plastic sleeve connects directly to the chassis exit tube? No coupler in between? So that grey part is part of the sleeve.
Posted: Sat Dec 24, 2005 5:03 am
by Gene-C
mine has a sleeve that you put on the cable. I took them off the old cables
Posted: Sat Dec 24, 2005 6:42 am
by Gene-C
The sleeve was part of the cable/housing.....not part of the car.